The GATE Grind

GATE 2018 AE – Previous Year Questions with Solutions

All 65 questions of GATE 2018 AE with answers and explanations. Read each question, then practise it by topic or as a full paper.

65 questions worth 100 marks in all (30 1-mark, 35 2-mark). Subjects covered: Engineering Mathematics (17), Flight Mechanics & Space Dynamics (15), General Aptitude (10), Structures (9), Aerodynamics (7), Propulsion (7).

Practise this paper in The GATE Grind →

  1. Question 1 (1 mark, Multiple choice) – “The dress her so well that they all immediately her on her appearance.” The words that best fill the blanks in the above sentence are
  2. Question 1 (1 mark, Multiple choice) – Let 𝑎⃗, 𝑏⃗⃗ be two distinct vectors that are not parallel. The vector 𝑐⃗= 𝑎⃗× 𝑏⃗⃗ is
  3. Question 2 (1 mark, Multiple choice) – Consider the function 𝑓(𝑥, 𝑦) = 𝑥2 2 + 𝑦2 3 −5. All the roots of this function
  4. Question 2 (1 mark, Multiple choice) – “The judge’s standing in the legal community, though shaken by false allegations of wrongdoing, remained .” The word that best fills the blank in the…
  5. Question 3 (1 mark, Multiple choice) – Find the missing group of letters in the following series: BC, FGH, LMNO,
  6. Question 3 (1 mark, Multiple choice) – Consider a vector field given by 𝑥𝑖̂ + 𝑦𝑗̂ + 𝑧𝑘̂. This vector field is
  7. Question 4 (1 mark, Multiple choice) – A jet aircraft is initially flying steady and level at its maximum endurance condition. For the aircraft to fly steady and level, but faster at the…
  8. Question 4 (1 mark, Multiple choice) – The perimeters of a circle, a square and an equilateral triangle are equal. Which one of the following statements is true?
  9. Question 5 (1 mark, Multiple choice) – The pilot of a conventional airplane that is flying steady and level at some altitude, deflects the port side aileron up and the starboard aileron…
  10. Question 5 (1 mark, Multiple choice) – The value of the expression 1 1+log𝑢𝑣𝑤+ 1 1+log𝑣𝑤𝑢+ 1 1+log𝑤𝑢𝑣 is .
  11. Question 6 (2 marks, Multiple choice) – Forty students watched films A, B and C over a week. Each student watched either only one film or all three. Thirteen students watched film A, sixteen…
  12. Question 6 (1 mark, Multiple choice) – A NACA 0012 airfoil has a trailing edge flap. The airfoil is operating at an angle of attack of 5 degrees with un-deflected flap. If the flap is now…
  13. Question 7 (1 mark, Multiple choice) – An airplane requires a longer ground roll to lift-off on hot summer days because
  14. Question 7 (2 marks, Multiple choice) – A wire would enclose an area of 1936 m2, if it is bent into a square. The wire is cut into two pieces. The longer piece is thrice as long as the…
  15. Question 8 (2 marks, Multiple choice) – A contract is to be completed in 52 days and 125 identical robots were employed, each operational for 7 hours a day. After 39 days, five-seventh of…
  16. Question 8 (1 mark, Multiple choice) – The velocity profile in an incompressible, laminar boundary layer is shown in the figure below. U is the free-stream velocity, u(y) is the stream-wise…
  17. Question 9 (1 mark, Multiple choice) – The tangential velocity component ‘V’ of a spacecraft, which is in a circular orbit of radius ‘R’ around a spherical Earth (µ = GM → gravitational…
  18. Question 9 (2 marks, Multiple choice) – A house has a number which needs to be identified. The following three statements are given that can help in identifying the house number. i. If the…
  19. Question 10 (1 mark, Multiple choice) – Equation of the trajectory of a typical space object around any planet, in polar coordinates (r, θ) (i.e. a general conic section geometry), is given…
  20. Question 10 (2 marks, Multiple choice) – An unbiased coin is tossed six times in a row and four different such trials are conducted. One trial implies six tosses of the coin. If H stands for…
  21. Question 11 (1 mark, Multiple choice) – In an elliptic orbit around any planet, the location at which a spacecraft has the maximum angular velocity is
  22. Question 12 (1 mark, Multiple choice) – The pitching moment of a positively cambered NACA airfoil about its leading edge at zero- lift angle of attack is
  23. Question 13 (1 mark, Multiple choice) – In a low-speed wind tunnel, the angular location(s) from the front stagnation point on a circular cylinder where the static pressure equals the…
  24. Question 14 (1 mark, Multiple choice) – A thermocouple, mounted flush in an insulated flat surface in a supersonic laminar flow of air measures the
  25. Question 15 (1 mark, Multiple choice) – A shock wave is moving into still air in a shock tube. Which one of the following happens to the air?
  26. Question 16 (1 mark, Multiple choice) – The highest limit load factor experienced by a civil transport aircraft is in the range
  27. Question 17 (1 mark, Multiple choice) – Determine the correctness or otherwise of the following statements, [a] and [r]: [a] A closed-section box beam configuration is used in aircraft…
  28. Question 18 (1 mark, Multiple choice) – The first law of thermodynamics is also known as conservation of
  29. Question 19 (1 mark, Multiple choice) – In an ideal gas turbine cycle, the expansion in a turbine is represented by
  30. Question 20 (1 mark, Numerical answer) – The determinant of the matrix [ 1 1 −1 2 1 0 3 1 1 ] is (accurate to one decimal place).
  31. Question 21 (1 mark, Numerical answer) – The theoretical maximum velocity (in m/s) of air expanding from a reservoir at 700 K is (accurate to two decimal places). Specific heat of air at…
  32. Question 22 (1 mark, Numerical answer) – For a damped single degree of freedom system with damping ratio of 0.1, ratio of two successive peak amplitudes of free vibration is (accurate to two…
  33. Question 23 (1 mark, Numerical answer) – The natural frequency (in rad/s) of the spring-mass system shown in the figure below is (accurate to one decimal place).
  34. Question 24 (1 mark, Numerical answer) – The stagnation pressures at the inlet and exit of a subsonic intake are 100 kPa and 98 kPa, respectively. The pressure recovery of this intake will be…
  35. Question 25 (1 mark, Numerical answer) – A combustor is operating with a fuel-air ratio of 0.03. If the stoichiometric fuel-air ratio of the fuel used is 0.06, the equivalence ratio of the…
  36. Question 26 (2 marks, Multiple choice) – The solution of the differential equation 𝑑2𝑦 𝑑𝑥2 + 3 𝑑𝑦 𝑑𝑥= 0, given that 𝑦= 0 and 𝑑𝑦 𝑑𝑥= 1 at 𝑥= 0 is
  37. Question 27 (2 marks, Multiple choice) – The relation between pressure (p) and velocity (V) for a steady, isentropic flow at two points along a streamline is, (c is a constant)
  38. Question 28 (2 marks, Multiple choice) – A thin airfoil is mounted in a low-speed, subsonic wind tunnel, in which the Mach number is 0.1. At a point on the airfoil, the pressure coefficient…
  39. Question 29 (2 marks, Multiple choice) – A solid circular shaft of diameter d is under pure torsion of magnitude T. The maximum tensile stress experienced at any point on the shaft is
  40. Question 30 (2 marks, Multiple choice) – A clamped-clamped beam, subjected to a point load P at the midspan, is shown in the figure below. The magnitude of the moment reaction at the two…
  41. Question 31 (2 marks, Multiple choice) – Which of the following statement(s) is/are true about the state of a body in plane strain condition? P: All the points in the body undergo…
  42. Question 32 (2 marks, Multiple choice) – An aircraft with a turbojet engine flies at a velocity of 100 m/s. If the jet exhaust velocity is 300 m/s, the propulsive efficiency of the engine,…
  43. Question 33 (2 marks, Multiple choice) – An aircraft with a turboprop engine produces a thrust of 500 N and flies at 100 m/s. If the propeller efficiency is 0.5, the shaft power produced by…
  44. Question 34 (2 marks, Multiple choice) – An axial compressor that generates a stagnation pressure ratio of 4.0, operates with inlet and exit stagnation temperatures of 300 K and 480 K,…
  45. Question 35 (2 marks, Multiple choice) – A rocket has an initial mass of 150 kg. After operating for a duration of 10 s, its final mass is 50 kg. If the acceleration due to gravity is 9.81…
  46. Question 36 (2 marks, Numerical answer) – Consider the vector field 𝑣⃗= − 𝑦 𝑟2 𝑖̂ + 𝑥 𝑟2 𝑗̂ ; where 𝑟= √𝑥2 + 𝑦2. The contour integral ∮𝑣⃗⋅𝑑𝑠⃗⃗⃗⃗⃗, where 𝑑𝑠⃗⃗⃗⃗⃗ is tangent to…
  47. Question 37 (2 marks, Numerical answer) – The magnitude of the x-component of a unit vector at the point (1, 1) that is normal to equi- potential lines of the potential function 𝜙(𝑟) = 1…
  48. Question 38 (2 marks, Numerical answer) – Assuming ISA standard sea level conditions (288.16 K, density of 1.225 kg/m3, g = 9.81 m/s2, R = 287 J/(kg-K)), the density (in kg/m3) of air at Leh,…
  49. Question 39 (2 marks, Numerical answer) – Consider a cubical tank of side 2 m with its top open. It is filled with water up to a height of 1 m. Assuming the density of water to be 1000 kg/m3,…
  50. Question 40 (2 marks, Numerical answer) – An aircraft with mass of 400,000 kg cruises at 240 m/s at an altitude of 10 km. Its lift to drag ratio at cruise is 15. Assuming g as 9.81 m/s2, the…
  51. Question 41 (2 marks, Numerical answer) – A statically-stable aircraft has a 𝐶𝐿𝛼= 5 (where the angle of attack, α, is measured in radians). The coefficient of moment of the aircraft about…
  52. Question 42 (2 marks, Numerical answer) – An aircraft with a gross weight of 2000 kg, has a speed of 130 m/s at sea level, where the conditions are: 1 atmosphere (pressure), 288 K…
  53. Question 43 (2 marks, Numerical answer) – A pitot probe on an aircraft in a steady, level flight records a pressure of 55,000 N/m2. The static pressure and density are 45,280 N/m2 and 0.6…
  54. Question 44 (2 marks, Numerical answer) – A spacecraft forms a circular orbit at an altitude of 150 km above the surface of a spherical Earth. Assuming the gravitational parameter, µ = 3.986 ×…
  55. Question 45 (2 marks, Numerical answer) – Air at 50 kPa pressure and 400 K temperature flows in a duct at Mach 3.0. A part of the flow leaks through an opening on the duct wall into the…
  56. Question 46 (2 marks, Numerical answer) – Consider a 200 half-angle wedge in a supersonic flow at Mach 3.0 at standard sea-level conditions. If the shock-wave angle on the wedge is 360, the…
  57. Question 47 (2 marks, Numerical answer) – The boundary layer thickness at the location of a sensor on a flat plate in an incompressible, laminar flow of air is required to be restricted to 1…
  58. Question 48 (2 marks, Numerical answer) – Gross weight of an airplane is 7000 N, wing area is 16 m2, and the maximum lift coefficient is 2.0. Assuming density at the altitude as 1.23 kg/m3,…
  59. Question 49 (2 marks, Numerical answer) – A thin-walled tube with external radius of 100 mm and wall thickness of 2 mm, is fixed at one end. It is subjected to a compressive force of 1 N…
  60. Question 50 (2 marks, Numerical answer) – A 1 m long massless cantilever beam oscillates at 2Hz, while a 60 kg mass is attached at the tip of it. The flexural rigidity of the beam (in kN-m2)…
  61. Question 51 (2 marks, Numerical answer) – A cantilever beam having a rectangular cross-section of width 60 mm and depth 100 mm, is made of aluminum alloy. The material mechanical properties…
  62. Question 52 (2 marks, Numerical answer) – The components of stress in a body under plane stress condition, in the absence of body forces, is given by: 𝜎𝑥𝑥= 𝐴𝑥2; 𝜎𝑦𝑦= 12𝑥2 −6𝑦2 and…
  63. Question 53 (2 marks, Numerical answer) – An axial compressor rotor with 50 % degree of reaction, operates with an axial velocity of 200 m/s. The absolute flow angle at the inlet of the rotor…
  64. Question 54 (2 marks, Numerical answer) – The relative velocity of air leaving a straight radial impeller of a centrifugal compressor is 100 m/s. If the impeller tip speed is 200 m/s, for a…
  65. Question 55 (2 marks, Numerical answer) – An aircraft wind tunnel model, having a pitch axis mass moment of inertia (Iyy) of 0.014 kg-m2, is mounted in such a manner that it has pure pitching…