The GATE Grind

GATE Machine Design: Fatigue strength and S-N diagram – Previous Year Questions

14 GATE previous year questions on Fatigue strength and S-N diagram (Machine Design, Mechanical Engineering) with answers and explanations, from every paper.

14 questions worth 20 marks in all (8 1-mark, 6 2-mark). Asked between 2016 and 2025, so you can see how the topic has been tested over time.

  1. GATE 2017 ME (ME1) Q53 (2 marks, Numerical answer) – A machine element has ultimate strength u=600 N/mm² and endurance limit en=250 N/mm². Its fatigue curve is shown on a log–log plot. For a life of…
  2. GATE 2016 ME (ME2) Q48 (2 marks, Multiple choice) – In a structural member under fatigue loading, the minimum and maximum stresses developed at the critical point are 50 MPa and 150 MPa, respectively.…
  3. GATE 2017 ME (ME2) Q21 (1 mark, Numerical answer) – A ductile machine component has minimum and maximum stresses −50 and 50 MPa. Its corrected endurance limit is 100 MPa and yield strength is 300 MPa.…
  4. GATE 2018 ME (ME2) Q31 (1 mark, Numerical answer) – For fully reversed loading, fatigue life follows a=1100N-0.15, where stress amplitude is in MPa and N is life in cycles. Find the maximum allowable…
  5. GATE 2018 ME (ME2) Q48 (2 marks, Numerical answer) – A square bar of side a is subjected to a steady load of 60 kN and another load fluctuating from −10 kN to 90 kN. Corrected endurance limit is 150 MPa,…
  6. GATE 2019 ME (ME2) Q18 (1 mark, Multiple choice) – The endurance limit of a beam under pure bending decreases with which combination?
  7. GATE 2019 ME (ME1) Q32 (1 mark, Numerical answer) – A high-cycle fatigue specimen has mean cyclic stress +140 MPa and minimum stress −70 MPa. Find R-ratio (minimum/maximum stress), to one decimal place.
  8. GATE 2020 ME (ME2) Q31 (1 mark, Numerical answer) – A machine member experiences fluctuating stress = 0(8 t). Material endurance limit is 350 MPa and design factor of safety 3.5. Find maximum allowable…
  9. GATE 2021 ME (ME2) Q65 (2 marks, Numerical answer) – The figure shows the relationship between fatigue strength (S) and fatigue life (N) of a material. The fatigue strength of the material for a life of…
  10. GATE 2021 ME (ME1) Q64 (2 marks, Numerical answer) – A machine part in the form of cantilever beam is subjected to fluctuating load as shown in the figure. The load varies from 800 N to 1600 N. The…
  11. GATE 2022 ME (ME1) Q29 (1 mark, Multiple select) – Which of the following methods can improve the fatigue strength of a circular mild steel (MS) shaft?
  12. GATE 2023 ME Q18 (1 mark, Multiple choice) – The S-N curve from a fatigue test for steel is shown. Which one of the options gives the endurance limit?
  13. GATE 2024 ME Q26 (1 mark, Multiple choice) – Which one of the following failure theories is the most conservative design approach against fatigue failure?
  14. GATE 2025 ME Q43 (2 marks, Multiple choice) – The endurance limit of a specific grade of steel is same as its yield strength. The ultimate strength of this grade of steel is twice of its yield…