GATE Machine Design: Shafts and springs – Previous Year Questions
10 GATE previous year questions on Shafts and springs (Machine Design, Mechanical Engineering) with answers and explanations, from every paper.
10 questions worth 13 marks in all (7 1-mark, 3 2-mark). Asked between 2016 and 2026, so you can see how the topic has been tested over time.
- GATE 2016 ME (ME1) Q22 – The spring constant of a helical compression spring DOES NOT depend on
- GATE 2017 ME (ME2) Q43 – A helical compression spring of circular wire has maximum shear stress 24 MPa under a compressive load. With the same load, both wire diameter and…
- GATE 2018 ME (ME2) Q30 – A hollow circular shaft of inner radius 10 mm, outer radius 20 mm and length 1 m acts as a torsional spring. Its shear modulus is 150 GPa. Find…
- GATE 2018 ME (ME1) Q18 – For an Oldham coupling between two shafts, which are correct? I. Torsional load transfers along the shaft axis. II. It provides shaft velocity ratio…
- GATE 2018 ME (ME1) Q31 – A compression helical spring’s wire diameter increases by 2%. The change in stiffness, to two decimals, is %.
- GATE 2020 ME (ME2) Q41 – A helical spring has spring constant k. Wire diameter, spring diameter and number of coils are all doubled. Find the new spring constant.
- GATE 2020 ME (ME1) Q19 – A helical gear with 20° pressure angle and 30° helix angle is mounted at the midspan of a shaft supported between two end bearings. Identify the…
- GATE 2021 ME (ME1) Q29 – Shear stress distribution on the cross-section of the coil wire in a helical compression spring is shown in the figure. This shear stress distribution…
- GATE 2022 ME (ME2) Q53 – A shaft AC rotating at a constant speed carries a thin pulley of radius r=0.4 m at the end C which drives a belt. A motor is coupled at the end A of…
- GATE 2026 ME Q19 – A closely coiled helical compression spring of mean coil diameter D and wire diameter d, is loaded by an axial force F. The maximum shear stress…