The GATE Grind

GATE Geotechnical Engineering: Stress distribution in soils, Boussinesq theory, pressure bulbs – Previous Year Questions

9 GATE previous year questions on Stress distribution in soils, Boussinesq theory, pressure bulbs (Geotechnical Engineering, Civil Engineering) with answers and explanations, from every paper.

9 questions worth 12 marks in all (6 1-mark, 3 2-mark). Asked between 2017 and 2024, so you can see how the topic has been tested over time.

  1. GATE 2017 CE (CE1) Q21 (1 mark, Multiple choice) – A uniformly distributed line load of 500 kN/m acts on the ground surface. Using Boussinesq theory, find the ratio of vertical stress at depth 2 m to…
  2. GATE 2017 CE (CE2) Q54 (2 marks, Numerical answer) – Four 5000 kN point loads act at corners A, B, C, D of a 4 m × 4 m square as shown. By Boussinesq theory, vertical stress increment 5 m below centre M,…
  3. GATE 2018 CE (CE2) Q20 (1 mark, Multiple choice) – Which statement is NOT correct?
  4. GATE 2019 CE (CE2) Q62 (2 marks, Numerical answer) – A 2 m × 4 m rectangular footing carries uniform pressure 120 kPa. Use 2:1 stress dispersion to find vertical stress increment 2 m below its base…
  5. GATE 2019 CE (CE1) Q35 (1 mark, Numerical answer) – A concentrated 500 kN load acts on an elastic half-space. According to Boussinesq’s theory, find the ratio of increases in vertical normal stress at…
  6. GATE 2022 CE (CE2) Q32 (1 mark, Numerical answer) – A concentrically loaded isolated square footing of size 2 m × 2 m carries a concentrated vertical load of 1000 kN. Considering Boussinesq’s theory of…
  7. GATE 2022 CE (CE1) Q32 (1 mark, Numerical answer) – A concentrated vertical load of 3000 kN is applied on a horizontal ground surface. Points P and Q are at depths 1 m and 2 m below the ground,…
  8. GATE 2023 CE (CE1) Q41 (2 marks, Multiple choice) – Consider that a force P is acting on the surface of a half-space (Boussinesq's problem). The expression for the vertical stress ( z) at any point (r,…
  9. GATE 2024 CE (CE2) Q22 (1 mark, Multiple choice) – The contact pressure distribution shown in the figure belongs to a