GATE Fluid Mechanics (XE1): Integral Analysis for a Control Volume – Previous Year Questions
21 GATE previous year questions on Integral Analysis for a Control Volume (Fluid Mechanics (XE1), Engineering Sciences) with answers and explanations, from every paper.
21 questions worth 36 marks in all (6 1-mark, 15 2-mark). Asked between 2019 and 2026, so you can see how the topic has been tested over time.
- GATE 2020 XE — all source sections Q22 – Figures show velocity and shear-stress profiles for duct flow. In each option, curve 1 is the velocity profile and curve 2 is the shear-stress…
- GATE 2020 XE — all source sections Q36 – A hydroelectric power plant takes in 30 m3/s of water through its turbine and discharges it to the atmosphere with V 2=2 m/s. Total head loss in the…
- GATE 2020 XE — all source sections Q40 – A venturimeter with a 75 mm throat is placed in a 150 mm diameter pipeline carrying water at 25°C. The pressure drop between the upstream tap and the…
- GATE 2020 XE — all source sections Q41 – A water jet with velocity V jet impinges normally on a moving flat plate with velocity V plate and splits equally into two halves as shown. The jet…
- GATE 2019 XE — all source sections Q42 – An incompressible fluid flows past a flat plate, as shown in the figure, with uniform inlet velocity profile u=U and parabolic exit velocity profile…
- GATE 2019 XE — all source sections Q43 – A jet engine is tested on a thrust stand as shown in the figure. The axial intake air velocity is 100 m/s; axial exhaust gas velocity is 250 m/s;…
- GATE 2023 XE — all source sections Q22 – Match the following measuring instruments with the appropriate figures. I – Pitot probe II – Pitot-static probe III – Piezometer
- GATE 2023 XE — all source sections Q36 – A water jet (density = 1000 kg/m3) is approaching a vertical plate, having an orifice at the center, as shown in the figure. While a part of the jet…
- GATE 2023 XE — all source sections Q37 – Water (density = 1000 kg/m3) and alcohol (specific gravity = 0.7) enter a Y-shaped channel at flow rates of 0.2 m3/s and 0.3 m3/s, respectively. Their…
- GATE 2023 XE — all source sections Q40 – Water (density = 1000 kg/m3) flows steadily with a flow rate of 0.05 m3/s through a venturimeter having throat diameter of 100 mm. If the pipe…
- GATE 2024 XE — all source sections Q26 – Let 𝑟 , 𝑉⃗ , and 𝑚 be position vector, velocity vector, and mass, respectively in a control mass system. Which one of the following properties is…
- GATE 2024 XE — all source sections Q38 – A circular water jet of diameter 50 mm impinges with a velocity of 18 m/s normal to a plate. The density of water is 1000 kg/m3 and gravity force is…
- GATE 2024 XE — all source sections Q39 – Water flows steadily through a horizontal1-m-diameter pipe at inlet speed12 m/s. A0.6-m circular side hole loses4.53 m³/s. Find downstream main-pipe…
- GATE 2024 XE — all source sections Q42 – A steady incompressible irrotational flow passes through a horizontal concentric reducer from 12-cm to 4-cm diameter. Pressures are55 and 27 kPa.…
- GATE 2025 XE — all source sections Q25 – Statement of Reynolds Transport Theorem is given below with three blanks. The rate of change of extensive property can be calculated by summing the…
- GATE 2025 XE — all source sections Q34 – Steady incompressible flow travels A→B→C→D. The diagram shows total-energy line TEL and hydraulic-grade line HGL. Which sequence describes connector…
- GATE 2025 XE — all source sections Q40 – A steady control volume has four sections, listed as(type, density kg/m³, outward-normal speed magnitude m/s, area m², specific energy J/kg):1: inlet,…
- GATE 2025 XE — all source sections Q42 – Water flows through a pipe of diameter 20 cm at a flow rate of 0.025 m3/s. A pitot- static tube is placed at the centre of the pipe and indicates the…
- GATE 2026 XE — all source sections Q25 – Three same-diameter siphons discharge from reservoirs to outlets at the same vertical drop h, with differing crest shapes/heights shown. Neglect…
- GATE 2026 XE — all source sections Q30 – The horizontal water-pipe piezometer/Pitot arrangement has h₁=4 cm, h₂=6 cm, h₃=5 cm as shown. Flow is steady, laminar, incompressible; ρ=1000 kg/m³,…
- GATE 2026 XE — all source sections Q36 – A downward vertical jet of diameter d₁ and speed U hits a horizontal plate with a concentric hole d₂<d₁. Fluid through the hole retains speed U; the…