GATE Mechanics of Materials: Shear force and bending moment diagrams – Previous Year Questions
9 GATE previous year questions on Shear force and bending moment diagrams (Mechanics of Materials, Mechanical Engineering) with answers and explanations, from every paper.
9 questions worth 16 marks in all (2 1-mark, 7 2-mark). Asked between 2017 and 2026, so you can see how the topic has been tested over time.
- GATE 2017 ME (ME2) Q18 – A loaded cantilever of uniform cross section has bending moment M(x)=5x2+10x N mm, where x is distance in mm from the free end. The shear-force…
- GATE 2017 ME (ME2) Q19 – A cantilever of length L and flexural rigidity EI carries a free-end load P. Its bending strain energy, neglecting transverse shear, is .
- GATE 2020 ME (ME1) Q50 – A unit-width (1 m into the plane) barrier between two water tanks is modelled as a cantilever, with water depths 4 m and 1 m on opposite sides as…
- GATE 2020 ME (ME1) Q51 – Find the magnitude of reaction force at joint C of the hinge beam shown (kN), to two decimals.
- GATE 2023 ME Q39 – A beam of length L is loaded in the xy-plane by a uniformly distributed load, and by a concentrated tip load parallel to the z-axis, as shown in the…
- GATE 2024 ME Q41 – Which of the following beam(s) is/are statically indeterminate?
- GATE 2024 ME Q53 – A horizontal beam of length 1200 mm is pinned at the left end and is resting on a roller at the other end as shown in the figure. A linearly varying…
- GATE 2025 ME Q57 – A simply supported beam of length 1 m is subjected to a uniformly distributed bending moment of 1 N m per m throughout the length as shown in the…
- GATE 2026 ME Q40 – A cantilever beam of length L is subjected to a concentrated load P and a moment M as shown in the figure below. Neglecting the mass of the beam,…