GATE Steel Structures: Plastic analysis of beams and portal frames – Previous Year Questions
11 GATE previous year questions on Plastic analysis of beams and portal frames (Steel Structures, Civil Engineering) with answers and explanations, from every paper.
11 questions worth 20 marks in all (2 1-mark, 9 2-mark). Asked between 2016 and 2026, so you can see how the topic has been tested over time.
- GATE 2016 CE (CE2) Q48 – A fixed-end beam has two segments of length L with plastic capacities 2M p and M p, as shown. A concentrated load P acts at 2L/3 from the left…
- GATE 2016 CE (CE1) Q47 – A propped cantilever of span L carries a vertical concentrated load at the mid-span. If the plastic moment capacity of the section is Mp, the…
- GATE 2018 CE (CE2) Q50 – A prismatic propped cantilever of span L and plastic moment capacity M p carries a concentrated load at midspan. If collapse load is M p/L, then α is…
- GATE 2018 CE (CE1) Q52 – The symmetrical welded I-section shown has 140 mm wide, 9 mm thick flanges, overall depth 200 mm and web thickness 6.1 mm. Its weaker-axis plastic…
- GATE 2019 CE (CE1) Q43 – The T-section shown changes from fully elastic to fully plastic. By how much does the neutral-axis depth measured from the top decrease? The flange is…
- GATE 2020 CE (CE2) Q15 – The ratio of plastic moment capacity to yield moment capacity is called .
- GATE 2021 CE (CE2) Q38 – A simply supported prismatic steel beam of span L has a point load P at L/3 from the left. Which statement compares collapse plastic moments from…
- GATE 2022 CE (CE2) Q38 – For the square steel beam cross-section shown in the figure, the shape factor about z−z axis is S and the plastic moment capacity is MP. Consider…
- GATE 2024 CE (CE2) Q33 – The steel angle section shown in the figure has elastic section modulus of 150.92 cm3 about the horizontal X−X axis, which passes through the centroid…
- GATE 2026 CE (CE2) Q49 – A rigid-jointed portal frame, shown in the figure, consists of beam and columns of equal length L. The frame has a fixed support at one end and a…
- GATE 2026 CE (CE1) Q52 – The cross-section of a steel T-beam is shown in the figure where all dimensions are in mm. The plastic section modulus of the given cross-section is…