GATE Fluid Mechanics: Flow in pipes and pipe networks – Previous Year Questions
13 GATE previous year questions on Flow in pipes and pipe networks (Fluid Mechanics, Civil Engineering) with answers and explanations, from every paper.
13 questions worth 23 marks in all (3 1-mark, 10 2-mark). Asked between 2016 and 2026, so you can see how the topic has been tested over time.
- GATE 2017 CE (CE1) Q33 – A triangular pipe network is shown. Head loss in each pipe is h f=rQ1.8 in consistent units. Pipe AB has r=1 and BC has r=2. A supply of 100 at A is…
- GATE 2016 CE (CE2) Q58 – A penstock of 1 m diameter and 5 km length is used to supply water from a reservoir to an impulse turbine. A nozzle of 15 cm diameter is fixed at the…
- GATE 2017 CE (CE2) Q59 – A horizontal 100 mm diameter pipe carries 0.01 m³/s at Reynolds number 800. Take g = 9.81 m/s². Head loss per kilometre, to one decimal place, is m.
- GATE 2018 CE (CE2) Q58 – A rough pipe has diameter 0.5 m, length 300 m and roughness height k = 0.25 mm. Water velocity is 3 m/s and kinematic viscosity 0.910-6 m²/s. For…
- GATE 2019 CE (CE2) Q59 – Two pipes of equal length, diameter and roughness withdraw water from a reservoir, discharging freely to atmosphere. They are connected in series in…
- GATE 2019 CE (CE1) Q60 – Two reservoirs are connected by a full-running siphon of total length 5000 m and diameter 0.10 m. The inlet leg to the summit is 2000 m and reservoir…
- GATE 2020 CE (CE2) Q59 – A 600 mm diameter, 400 m long cast-iron pipe carries tank water to a free-air discharge 4.5 m below the tank surface. Darcy friction factor is 0.018…
- GATE 2020 CE (CE1) Q59 – Reservoirs P, Q and R connect through pipes at junction S as shown. Piezometric head at S is 100 m; pipe S–R length is 180 m. Take g = 9.81 m/s² and…
- GATE 2022 CE (CE1) Q57 – Two reservoirs are connected by two parallel pipes of equal length and of diameters 20 cm and 10 cm, as shown in the figure (not drawn to scale). When…
- GATE 2024 CE (CE2) Q57 – A 500 m long water distribution pipeline P with diameter 1.0 m, is used to convey 0.1 m3/s of flow. A new pipeline Q, with the same length and flow…
- GATE 2025 CE (CE2) Q33 – Consider steady flow of water in the series pipe system shown below, with specified discharge. The diameters of Pipes A and B are 2 m and 1 m,…
- GATE 2026 CE (CE2) Q54 – A centrifugal pump is delivering water from an underground tank to an overhead reservoir against a static head of 35 m through a 2 km long, 250 mm…
- GATE 2026 CE (CE1) Q16 – Two reservoirs having different water levels are connected by two long parallel pipelines of same length and same material but having diameters of 600…