The GATE Grind

GATE 2020 MN – Previous Year Questions with Solutions

All 65 questions of GATE 2020 MN with answers and explanations. Read each question, then practise it by topic or as a full paper.

65 questions worth 100 marks in all (30 1-mark, 35 2-mark). Subjects covered: Mining Methods and Machinery (15), General Aptitude (10), Geomechanics and Ground Control (10), Engineering Mathematics (9), Mining Geology, Mine Development and Surveying (8), Surface Environment, Mine Ventilation and Underground Hazards (7), Mineral Economics, Mine Planning, Systems Engineering (6).

Practise this paper in The GATE Grind →

  1. Question 1 (1 mark, Multiple choice) – Rajiv Gandhi Khel Ratna Award was conferred Mary Kom, a six-time world boxing champion, recently in a ceremony the Rashtrapati Bhawan in New Delhi.
  2. Question 2 (1 mark, Multiple choice) – Despite a string of poor performances, the chances of K. L. Rahul’s selection in the team are .
  3. Question 3 (1 mark, Multiple choice) – Complete the analogy: Cover : Uncover :: Associate : .
  4. Question 4 (1 mark, Multiple choice) – Floods affected the summer-sown kharif crops. Officials believe this loss can be recovered through winter-sown rabi crops so the country can achieve…
  5. Question 5 (1 mark, Multiple choice) – Find the difference between the sum of the first 2n natural numbers and the sum of the first n odd natural numbers.
  6. Question 6 (2 marks, Multiple choice) – Repo rate is the rate at which RBI lends to commercial banks; reverse repo is the rate at which RBI borrows from them. Which statement follows?
  7. Question 7 (2 marks, Multiple choice) – P,Q,R,S,T,U,V,W sit around a circular table. S is opposite W; U is second to the right of R; T is third to the left of R; V neighbours S. Which must…
  8. Question 8 (2 marks, Multiple choice) – Delhi and Agra are 233 km apart. P travels from Delhi to Agra; Q starts from Agra to Delhi one hour later. They meet 75 minutes after Q starts. Both…
  9. Question 9 (2 marks, Multiple choice) – A 44 matrix M=[m ij] has all diagonal entries zero and satisfies m ij=-m ji. What is the minimum number of elements needed to specify it?
  10. Question 10 (2 marks, Multiple choice) – The chart shows profit percentages of companies P and Q during 2013–2018. Both invest a fixed, equal amount every year. Find the ratio of P’s total…
  11. Question 11 (1 mark, Multiple choice) – The eigenvalues of the matrix A=bmatrix1&4\\3&2bmatrix are
  12. Question 12 (1 mark, Multiple choice) – For the electric delay detonator shown in the figure, the components P, Q and R, respectively, are
  13. Question 13 (1 mark, Multiple choice) – Match the following safety arrangements for a surface-to-underground shaft hoist with their corresponding safety functions. Hoisting safety…
  14. Question 14 (1 mark, Multiple choice) – The fore bearings and back bearings of the lines of an open compass traverse are given below. Line PQ: 132°30′, 313°30′; QR: 123°30′, 303°30′; RS:…
  15. Question 15 (1 mark, Multiple choice) – The plane stress condition is given by
  16. Question 16 (1 mark, Multiple choice) – Match the following metals with their corresponding minerals. Metals: P—copper; Q—tungsten; R—lead; S—zinc. Minerals: 1—galena; 2—sphalerite;…
  17. Question 17 (1 mark, Multiple choice) – Match the wire-rope types with their corresponding cross-sectional diagrams. Rope types: P—round strand; Q—half-locked coil; R—flattened strand;…
  18. Question 18 (1 mark, Multiple choice) – The ‘ratchet and pawl’ mechanism in a jack hammer drill
  19. Question 19 (1 mark, Multiple choice) – Post-pillar method of stoping is a variant of
  20. Question 20 (1 mark, Multiple choice) – ‘Cross-measure borehole method’ is used for
  21. Question 21 (1 mark, Multiple choice) – The dry and wet bulb temperatures at the inlet of the airstream are 30 °C and 25 °C, respectively. At the outlet, the corresponding temperatures are…
  22. Question 22 (1 mark, Multiple choice) – For a mixture of inflammable gases, the lower and upper explosibility limits can be computed using
  23. Question 23 (1 mark, Multiple choice) – The code for the lowest category of mineral resources under the United Nations Framework Classification (UNFC) system is
  24. Question 24 (1 mark, Multiple choice) – Match the following sampling patterns with the corresponding sampling types. Patterns P, Q, R and S are shown in the figure. Types: 1—regular;…
  25. Question 25 (1 mark, Multiple choice) – In the context of gas testing using a flame safety lamp, the correct statement is
  26. Question 26 (1 mark, Numerical answer) – For x in the range [-3,3], the maximum value of the function f(x)=x3-6x2+9x+15 is (round off to 1 decimal place).
  27. Question 27 (1 mark, Numerical answer) – A rock sample has coefficient of thermal diffusivity 1.28210-6 m2/s, specific heat 900 J/(kg °C) and density 2600 kg/m3. The coefficient of thermal…
  28. Question 28 (1 mark, Numerical answer) – A random variable X has the following probability mass function: x: 3, 6, 8, 12; f(x): 1/2, 1/4, 1/8, 1/8. The expected value of X is (round off to 1…
  29. Question 29 (1 mark, Numerical answer) – A random sample has five observations: 11, 14, 15, 13 and 12. The coefficient of variation of the sample is (round off to 3 decimal places).
  30. Question 30 (1 mark, Numerical answer) – Rock strata has unit weight of 25 kN/m3 and Poisson's ratio 1/3. At a depth of 200 m, the horizontal stress in MPa is (round off to 1 decimal place).
  31. Question 31 (1 mark, Numerical answer) – A shovel of bucket capacity 4.2 m3 makes 900 passes per day with a fill factor of 0.8. If the swell factor of the rock is 1.4, then the in-situ volume…
  32. Question 32 (1 mark, Numerical answer) – A cylindrical sample of granular material has length 10 cm, diameter 5 cm, and weight 350 g. Assume the sample is completely dry with specific gravity…
  33. Question 33 (1 mark, Numerical answer) – The following consecutive readings were taken at uniform intervals with a level and a levelling staff on continuously sloping ground: 0.405, 1.035,…
  34. Question 34 (1 mark, Numerical answer) – The cost of a slurry pump is Rs. 50,000 and it has an estimated life of 7 years. If the salvage value is Rs. 8,000, the annual depreciation following…
  35. Question 35 (1 mark, Numerical answer) – In a mine bench, the shovel loading time follows an exponential distribution with a mean loading time of 5 min per dumper. The arrival rate of dumpers…
  36. Question 36 (2 marks, Multiple choice) – For w=et-tet+t, the value of dwdt is
  37. Question 37 (2 marks, Multiple choice) – For the differential equation y1-x2\,dy+x1-y2\,dx=0, assuming the constant of integration to be C, the general solution is
  38. Question 38 (2 marks, Multiple choice) – A belt-drive used for power transmission between two parallel shafts has a belt of mass 1.2 kg/m and maximum allowable belt tension 2250 N. If the…
  39. Question 39 (2 marks, Multiple choice) – An air receiver of a compressor, having volume 0.5 m3, supplies air for charging ANFO in drill holes. During the charging process, its absolute…
  40. Question 40 (2 marks, Multiple choice) – A conveyor belt consumes 60 kW power while running at a speed of 3.0 m/s. The angle of lap is 180° and the coefficient of friction between belt and…
  41. Question 41 (2 marks, Multiple choice) – A linear programming problem is stated below. Maximize Z=3x 1+5x 2, subject to 2x 1+x 28, 6x 1+8x 230, and x 1,x 20. The objective function has
  42. Question 42 (2 marks, Multiple choice) – An explosive mixture has 80 g of ammonium nitrate (NH 4NO 3) and 14 g of fuel oil (C 10H 20). The oxygen balance in the mixture is
  43. Question 43 (2 marks, Multiple choice) – A cylindrical sample of cross-sectional area A, length L, and Young's modulus E is subjected to a constant uniaxial load P. Within the elastic limit…
  44. Question 44 (2 marks, Numerical answer) – A surface mine production system along with the reliability of the individual components is shown in the figure. The system reliability is (round off…
  45. Question 45 (2 marks, Numerical answer) – The selling price of one rock bolt (in rupees) is given as S=(200-10n-0.5), where n is the number of bolts produced. The manufacturing cost has a…
  46. Question 46 (2 marks, Numerical answer) – Two underground mines are separated by a horizontal coal barrier 60 m thick. One mine is inundated, whereas the other has a blind heading 4.0 m wide…
  47. Question 47 (2 marks, Numerical answer) – Air enters from ambient atmosphere into a level duct of uniform cross-sectional area 0.2 m2 at a flow rate of 2.0 m3/s and density 1.2 kg/m3. The…
  48. Question 48 (2 marks, Numerical answer) – A sealed-off area air sample consists of 16.0% O 2, 3.0% CO 2, and the rest is N 2. Assume that the standard composition of atmospheric air is 21.0% O…
  49. Question 49 (2 marks, Numerical answer) – A diesel loader produces 60 L/s of exhaust fumes containing 5000 ppm of CO. The incoming air has 10 ppm of CO. The minimum amount of air flow, in…
  50. Question 50 (2 marks, Numerical answer) – The equation for peak particle velocity (PPV) from blast-induced ground vibration is PPV=k(D/Q)B, where k and B are site constants. The recorded…
  51. Question 51 (2 marks, Numerical answer) – An underground copper mine sends 2500 tonnes of ore per day to the concentrator plant, having an average grade of 1.2% Cu. The plant produces…
  52. Question 52 (2 marks, Numerical answer) – A mine gallery is supported by regularly placed roof bolts of 100 kN allowable pull force per bolt, as shown in the figure. Assuming unit weight of…
  53. Question 53 (2 marks, Numerical answer) – The slip circle of radius 30.0 m in an overburden slope is shown with its centre at point O. The tension crack is completely filled with water. For…
  54. Question 54 (2 marks, Numerical answer) – The function values at four points of x are shown: x=2,4,8,9 and f(x)=8,12,9,10, respectively. The area under the function, using the trapezoidal…
  55. Question 55 (2 marks, Numerical answer) – A particle starting from rest moves in a straight line such that after time t seconds, its acceleration is (6-t/4) cm/s2. When the acceleration…
  56. Question 56 (2 marks, Numerical answer) – A parallelepiped has edge vectors A=-4 i-10 j- k, B=7 i+9 j-2 k, and C=3 i+9 j+4 k. The volume of the parallelepiped is (round off to 1 decimal…
  57. Question 57 (2 marks, Numerical answer) – For a development heading, the blasting parameters are: cross-section 6.0 m × 5.0 m; total number of holes 72; number of trimmer holes 30; depth of…
  58. Question 58 (2 marks, Numerical answer) – The figure represents observations from a level survey of an underground gallery. If the reduced level of station A is 100.0 m, the reduced level of…
  59. Question 59 (2 marks, Numerical answer) – A tacheometer was set up at station P. With the staff held vertical and line of sight horizontal, readings were: line PA, bearing 210°, staff…
  60. Question 60 (2 marks, Numerical answer) – The geometry of a simple planar curve (ADB) is shown in the figure. The value of the mid-ordinate of the curve, in m, is (round off to 1 decimal…
  61. Question 61 (2 marks, Numerical answer) – A steel cube of side 50 mm is subjected to a uniform pressure of 200 MPa acting on each face. The Young's modulus and Poisson's ratio of the material…
  62. Question 62 (2 marks, Numerical answer) – In the figure shown, the friction coefficient between the block and the inclined plane is 0.2, and all pulleys are weightless. The weight of the block…
  63. Question 63 (2 marks, Numerical answer) – An assignment problem has the following costs. Rows are groups G1–G4 and columns tasks T1–T4: G1=(6,10,5,4); G2=(4,100,6,4); G3=(6,9,6,2);…
  64. Question 64 (2 marks, Numerical answer) – A vertical stoping block of length 60.0 m, height 40.0 m and average width 1.5 m has sharp boundary walls. The mining width is 2.0 m. Tonnage factors…
  65. Question 65 (2 marks, Numerical answer) – A bauxite ore body has four boreholes as shown. For each borehole, the alumina grade, ore-body thickness and triangular area of influence are shown in…