As per IS 456:2000 provisions for two-way slabs with continuous edges, the longitudinal steel reinforcement to be provided in the edge strip is based on
the calculated minimum bending moment
the area of longitudinal steel provided in the middle strip in the shorter span
the area of longitudinal steel provided in the middle strip in the longer span
the prescribed minimum cross-sectional area of longitudinal steel for slabs
Correct answer: (D) the prescribed minimum cross-sectional area of longitudinal steel for slabs
Explanation
In a two-way slab designed by the IS 456 coefficient method, the bending moments apply to the middle strips. The edge strips, each one-eighth of the span wide, get reinforcement parallel to the edge equal only to the minimum steel prescribed for slabs (0.12 % or 0.15 % of the cross-section depending on the steel grade).
More Design and detailing of beams and slabs questions
GATE 2025 CE (CE2) Q30– The design shear strength of a reinforced concrete rectangular beam with a width of 250 mm…
GATE 2025 CE (CE2) Q40– Consider a reinforced concrete beam section of 350 mm width and 600 mm depth. The beam is…
GATE 2025 CE (CE2) Q54– A reinforced concrete beam has a support section with width of 300 mm and effective depth…
GATE 2024 CE (CE1) Q17– The following figure shows the arrangement of formwork for casting a cantilever RC beam.…
GATE 2024 CE (CE1) Q30– Consider a balanced doubly-reinforced concrete section. If the material and other…
GATE 2024 CE (CE1) Q50– An inverted T-shaped concrete beam (B1) in the figure, with centroidal axis X − X, is…