GATE Electrical and Electronic Measurements: Oscilloscopes, Error analysis – Previous Year Questions
8 GATE previous year questions on Oscilloscopes, Error analysis (Electrical and Electronic Measurements, Electrical Engineering) with answers and explanations, from every paper.
8 questions worth 11 marks in all (5 1-mark, 3 2-mark). Asked between 2014 and 2025, so you can see how the topic has been tested over time.
- GATE 2015 EE (EE2) Q17 – The capacitive divider shown measures a 100 kV rms, 50 Hz bus. C1=1 μF and C2=9 μF each have ±10% tolerance. The maximum rms Vout in kV is .
- GATE 2015 EE (EE2) Q40 – A wattmeter’s coil resistances are 0.01 Ω and 1000 Ω, with negligible inductances. Connected as shown, it measures a 30 V load drawing 25 A at pf 0.8.…
- GATE 2017 EE (EE2) Q18 – Two parallel resistors have nominal values R 1,R 2 and additive uncertainties R 1, R 2. For equivalent resistance R, write R ,i= R/ R i. The standard…
- GATE 2014 EE (EE2) Q57 – Parallel resistors R₁ = 300 Ω and R₂ = 200 Ω each have tolerance 1%. Find equivalent-resistance tolerance.
- GATE 2014 EE (EE1) Q30 – In an oscilloscope screen, linear sweep is applied at the .
- GATE 2017 EE Q22 – The slope and level detector circuit in a CRO has a delay of 100 ns. The start-stop sweep generator has a response time of 50 ns. In order to display…
- GATE 2020 EE Q63 – The temperature of the coolant oil bath for a transformer is monitored using the circuit shown. It contains a thermistor with a temperature-dependent…
- GATE 2025 EE Q31 – The maximum percentage error in the equivalent resistance of two parallel-connected resistors of 100 Ω and 900 Ω with each having a maximum 5% error…