The GATE Grind

GATE Machine Design: Bolted, riveted and welded joints – Previous Year Questions

8 GATE previous year questions on Bolted, riveted and welded joints (Machine Design, Mechanical Engineering) with answers and explanations, from every paper.

8 questions worth 14 marks in all (2 1-mark, 6 2-mark). Asked between 2016 and 2026, so you can see how the topic has been tested over time.

  1. GATE 2016 ME (ME3) Q48 (2 marks, Numerical answer) – A bolted joint has four bolts arranged as shown in figure. The cross sectional area of each bolt is 25 mm2. A torque T = 200 N-m is acting on the…
  2. GATE 2017 ME (ME2) Q46 (2 marks, Numerical answer) – A single-plate clutch disc has inner and outer radii 20 and 40 mm. Friction coefficient varies as =0.01r with r in mm. It must transmit 18.85 kN mm.…
  3. GATE 2018 ME (ME2) Q18 (1 mark, Multiple choice) – Pre-tensioning a bolted joint is used to .
  4. GATE 2020 ME (ME1) Q49 (2 marks, Numerical answer) – A rectangular steel bar of length 500 mm, width 100 mm and thickness 15 mm is cantilevered to a 200 mm steel channel using four bolts as shown. For a…
  5. GATE 2021 ME (ME1) Q65 (2 marks, Numerical answer) – A cantilever beam of rectangular cross-section is welded to a support by means of two fillet welds as shown in figure. A vertical load of 2 kN acts at…
  6. GATE 2022 ME (ME1) Q40 (2 marks, Multiple choice) – A bracket is attached to a vertical column by means of two identical rivets U and V separated by a distance of 2a = 100 mm, as shown in the figure.…
  7. GATE 2025 ME Q61 (2 marks, Numerical answer) – Two plates of thickness 10 mm each are to be joined by a transverse fillet weld on one side and the resulting structure is loaded as shown in the…
  8. GATE 2026 ME Q21 (1 mark, Multiple choice) – A rectangular plate is perfectly welded to a gusset plate with parallel fillet weld joints as shown in the figure below. The length of the weld is l…