The GATE Grind

GATE Casting, Forming and Joining Processes: Plastic deformation and yield criteria, hot and cold working – Previous Year Questions

6 GATE previous year questions on Plastic deformation and yield criteria, hot and cold working (Casting, Forming and Joining Processes, Mechanical Engineering) with answers and explanations, from every paper.

6 questions worth 10 marks in all (2 1-mark, 4 2-mark). Asked between 2016 and 2025, so you can see how the topic has been tested over time.

  1. GATE 2017 ME (ME1) Q64 (2 marks, Numerical answer) – A sand-mould sprue has top diameter 20 mm and height 200 mm. Molten metal enters at 0.5 m/s. The mould is well ventilated; take g = 9.8 m/s² and…
  2. GATE 2016 ME (ME2) Q33 (1 mark, Multiple choice) – The value of true strain produced in compressing a cylinder to half its original length is
  3. GATE 2018 ME (ME2) Q56 (2 marks, Numerical answer) – A metal’s true stress (MPa)–true strain relation is =10200.4. Its initial cross-sectional area at zero stress and strain is 100 mm². Find its area at…
  4. GATE 2018 ME (ME1) Q60 (2 marks, Numerical answer) – A bar is compressed to half its original length. True-strain magnitude, to two decimals, is .
  5. GATE 2019 ME (ME1) Q44 (2 marks, Multiple choice) – The plane-strain forging block shown has zero z strain and uniaxial-compression yield strength 300 MPa, obeying Tresca’s criterion. The entire block…
  6. GATE 2025 ME Q22 (1 mark, Multiple choice) – The yield stress of a metal in uniaxial tension is 200 MPa. According to von Mises yield criterion, the yield stress (in MPa) of the metal in pure…