The GATE Grind

GATE Metrology and Inspection: Interferometry, form and finish measurement – Previous Year Questions

6 GATE previous year questions on Interferometry, form and finish measurement (Metrology and Inspection, Mechanical Engineering) with answers and explanations, from every paper.

6 questions worth 9 marks in all (3 1-mark, 3 2-mark). Asked between 2016 and 2026, so you can see how the topic has been tested over time.

  1. GATE 2016 ME (ME3) Q62 (2 marks, Numerical answer) – Two optically flat plates of glass are kept at a small angle θ as shown in the figure. Monochromatic light is incident vertically. If the wavelength…
  2. GATE 2017 ME (ME2) Q63 (2 marks, Numerical answer) – A pin of diameter 25+0.020 +0.010 mm is electroplated with thickness 2.0+0.005 mm. Neglect gauge tolerance. The GO ring-gauge diameter for the plated…
  3. GATE 2020 ME (ME2) Q22 (1 mark, Multiple choice) – The figure symbolically represents surface texture in a perpendicular lay orientation. I–VI mark specification positions. P: Maximum waviness height…
  4. GATE 2021 ME (ME1) Q20 (1 mark, Multiple choice) – Consider the surface roughness profile as shown in the figure. The center line average roughness (R a, in m) of the measured length (L) is
  5. GATE 2023 ME Q56 (2 marks, Numerical answer) – An optical flat is used to measure the height difference between a reference slip gauge A and a slip gauge B. Upon viewing via the optical flat using…
  6. GATE 2026 ME Q33 (1 mark, Multiple choice) – A two-dimensional surface profile is obtained over a sampling length by using a contact type stylus profilometer as shown in the figure below. A line…