GATE Structural Analysis: Influence lines and moving loads – Previous Year Questions
10 GATE previous year questions on Influence lines and moving loads (Structural Analysis, Civil Engineering) with answers and explanations, from every paper.
10 questions worth 17 marks in all (3 1-mark, 7 2-mark). Asked between 2017 and 2026, so you can see how the topic has been tested over time.
- GATE 2017 CE (CE1) Q51 – Beam ABCD has a simple support at A, an internal hinge at B, and simple supports at C and D. AB = BC = 4 m and CD = 10 m. For a moving concentrated…
- GATE 2019 CE (CE2) Q46 – A long 10 kN/m uniformly distributed load and a 60 kN concentrated load move together on beam ABCD shown; their relative positions are not fixed. Find…
- GATE 2020 CE (CE1) Q38 – A distributed load 50 kN/m may occupy any continuous or separate patches on girder PQRST shown. Find maximum negative (hogging) bending moment at R…
- GATE 2021 CE (CE1) Q14 – A propped cantilever EF carries a unit moving load. Using the positive-shear convention shown, which qualitative influence line describes shear at G?
- GATE 2022 CE (CE1) Q52 – Consider a simply supported beam PQ as shown in the figure. A truck having 100 kN on the front axle and 200 kN on the rear axle, moves from left to…
- GATE 2023 CE (CE2) Q17 – Muller-Breslau principle is used in analysis of structures for .
- GATE 2023 CE (CE1) Q54 – An idealised bridge truss is shown in the figure. The force in Member U 2L 3 is kN (round off to one decimal place).
- GATE 2024 CE (CE2) Q50 – The horizontal beam PQRS shown in the figure has a fixed support at point P, an internal hinge at point Q, and a pin support at point R. A…
- GATE 2025 CE (CE2) Q14 – Consider the pin-jointed truss shown in the figure. Influence line is drawn for the axial force in the member G-I, when a unit load travels on the…
- GATE 2026 CE (CE2) Q38 – A simply supported, linearly elastic, homogeneous, prismatic beam of length L and flexural rigidity EI is shown in the figure. The expression for the…