The GATE Grind

GATE Machining and Machine Tool Operations: Cutting tool materials, tool life and wear, economics of machining – Previous Year Questions

12 GATE previous year questions on Cutting tool materials, tool life and wear, economics of machining (Machining and Machine Tool Operations, Mechanical Engineering) with answers and explanations, from every paper.

12 questions worth 22 marks in all (2 1-mark, 10 2-mark). Asked between 2016 and 2026, so you can see how the topic has been tested over time.

  1. GATE 2017 ME (ME1) Q63 (2 marks, Numerical answer) – A 200 mm long block is slab milled with a 34 mm diameter cutter at depth of cut 2 mm and table feed 18 mm/min. Approach and overtravel are equal. Find…
  2. GATE 2016 ME (ME3) Q61 (2 marks, Numerical answer) – In a single point turning operation with cemented carbide tool and steel work piece, it is found that the Taylor’s exponent is 0.25. If the cutting…
  3. GATE 2016 ME (ME2) Q61 (2 marks, Numerical answer) – For a metal-cutting job, cutting cost is ₹18C/V and tooling cost is ₹270C/(TV), where C is constant, V is cutting speed in m/min and T is tool life in…
  4. GATE 2016 ME (ME1) Q60 (2 marks, Multiple choice) – The HSS tool-life equation is VT0.14f0.7d0.4=constant. A 30 min tool life is obtained at V = 45 m/min, f = 0.35 mm and d = 2.0 mm. If speed, feed and…
  5. GATE 2017 ME (ME2) Q30 (1 mark, Multiple choice) – Which statement about ultrasonic machining is true?
  6. GATE 2018 ME (ME2) Q59 (2 marks, Numerical answer) – Identical HSS twist drills make through holes at constant feed in 20 mm mild-steel plates. In test 1 a drill lasts 300 holes at 150 rpm; in test 2…
  7. GATE 2018 ME (ME1) Q23 (1 mark, Multiple choice) – Taylor tool-life exponent is n = 0.5. If cutting speed is reduced by 50%, new tool life divided by original tool life is .
  8. GATE 2019 ME (ME1) Q63 (2 marks, Numerical answer) – Taylor’s tool-life equation is VTn=C, with V in m/min and T in min. Tool X has n = 0.3, C = 60; tool Y has n = 0.6, C = 90. Find the cutting speed…
  9. GATE 2020 ME (ME2) Q55 (2 marks, Numerical answer) – Bars 250 mm long and 25 mm diameter are turned at feed 0.2 mm/rev. Each tool regrinding costs ₹20 and each tool change takes 1 minute. Tool life obeys…
  10. GATE 2024 ME Q60 (2 marks, Numerical answer) – A cutting tool provides a tool life of 60 minutes while machining with the cutting speed of 60 m/min. When the same tool is used for machining the…
  11. GATE 2025 ME Q63 (2 marks, Numerical answer) – Cylindrical workpieces of diameter 60 mm and length 400 mm are machined on a lathe at a cutting speed of 25 m min-1 and a feed of 0.2 mm rev-1. The…
  12. GATE 2026 ME Q64 (2 marks, Numerical answer) – A drill bit during its lifetime can produce 150 through holes in a plate at a drill-speed of 200 RPM. If the drill-speed increases to 300 RPM, then it…