The GATE Grind

GATE 2018 MN – Previous Year Questions with Solutions

All 65 questions of GATE 2018 MN with answers and explanations. Read each question, then practise it by topic or as a full paper.

65 questions worth 100 marks in all (30 1-mark, 35 2-mark). Subjects covered: Engineering Mathematics (23), General Aptitude (10), Surface Environment, Mine Ventilation and Underground Hazards (10), Mining Geology, Mine Development and Surveying (6), Geomechanics and Ground Control (6), Mining Methods and Machinery (6), Mineral Economics, Mine Planning, Systems Engineering (4).

Practise this paper in The GATE Grind →

  1. Question 1 (1 mark, Multiple choice) – “From where are they bringing their books? bringing books from .” The words that best fill the blanks in the above sentence are
  2. Question 1 (1 mark, Multiple choice) – If cos sin sin cos X θ θ θ θ ⎡ ⎤ =⎢ ⎥ − ⎣ ⎦ , then T XX is
  3. Question 2 (1 mark, Multiple choice) – The values of x satisfying the following condition are 4 3 0 3 6 x x − = −
  4. Question 2 (1 mark, Multiple choice) – “A investigation can sometimes yield new facts, but typically organized ones are more successful.” The word that best fills the blank in the above…
  5. Question 3 (1 mark, Multiple choice) – The area of a square is 𝑑. What is the area of the circle which has the diagonal of the square as its diameter?
  6. Question 3 (1 mark, Multiple choice) – An azimuth of 330° corresponds to a quadrant bearing of
  7. Question 4 (1 mark, Multiple choice) – What would be the smallest natural number which when divided either by 20 or by 42 or by 76 leaves a remainder of 7 in each case?
  8. Question 4 (1 mark, Multiple choice) – Tri-cone drill bit is a type of
  9. Question 5 (1 mark, Multiple choice) – What is the missing number in the following sequence? 2, 12, 60, 240, 720, 1440, , 0
  10. Question 5 (1 mark, Multiple choice) – Exposure of weak roof in junctions of a development district in a coal mine can be decreased by
  11. Question 6 (1 mark, Multiple choice) – The property that CANNOT be determined from uniaxial compressive strength test of a rock sample fitted with strain gauges is
  12. Question 6 (2 marks, Multiple choice) – In appreciation of the social improvements completed in a town, a wealthy philanthropist decided to gift Rs 750 to each male senior citizen in the…
  13. Question 7 (2 marks, Multiple choice) – If 𝑝𝑞𝑟≠0 and 𝑝−𝑥= 1 𝑞, 𝑞−𝑦= 1 𝑟, 𝑟−𝑧= 1 𝑝 , what is the value of the product 𝑥𝑦𝑧?
  14. Question 7 (1 mark, Multiple choice) – The radial stress concentration around a long circular tunnel excavated in rock is given by the curve
  15. Question 8 (1 mark, Multiple choice) – Ward-Leonard system is provided in the winding system in order to restrict
  16. Question 8 (2 marks, Multiple choice) – In a party, 60% of the invited guests are male and 40% are female. If 80% of the invited guests attended the party and if all the invited female…
  17. Question 9 (2 marks, Multiple choice) – In the figure below, ∠𝐷𝐸𝐶+ ∠𝐵𝐹𝐶 is equal to .
  18. Question 9 (1 mark, Multiple choice) – The equipment NOT related to extraction of coal from longwall face operation is
  19. Question 10 (1 mark, Multiple choice) – The correct figure depicting the extraction of contiguous seams in bord and pillar working is indicated by
  20. Question 10 (2 marks, Multiple choice) – A six sided unbiased die with four green faces and two red faces is rolled seven times. Which of the following combinations is the most likely outcome…
  21. Question 11 (1 mark, Multiple choice) – The significance of ‘potentially explosive mixture’ in Coward flammability diagram is -
  22. Question 12 (1 mark, Multiple choice) – Considering ‘I’ as ‘intake’ and ‘R’ as ‘return’, the ventilation symbol for the shaft-bottom air-lock in a coal mine is
  23. Question 13 (1 mark, Multiple choice) – From a coal seam of a mine 1000 tonnes of coal is produced per day. The seam has inflammable gas emission rate of 14000 m3 per day. Percentage of…
  24. Question 14 (1 mark, Multiple choice) – The temperature profiles and the plume patterns that are most likely to result are given in the figures. The dotted line represents ‘adiabatic lapse…
  25. Question 15 (1 mark, Multiple choice) – The inventory pattern shown does NOT represent the following.
  26. Question 16 (1 mark, Multiple choice) – The figure depicts a transportation problem along with the solution. The correct statement is
  27. Question 17 (1 mark, Numerical answer) – The degree of the differential equation 2 3 2 2 0 d x x dt + = is .
  28. Question 18 (1 mark, Numerical answer) – The slope of the line connecting the points (20, 6) and (40, 8) is .
  29. Question 19 (1 mark, Numerical answer) – Two contours of RL 60 m and 70 m are separated by 34 m measured along dip of the seam. The dip of the seam in degree is . Time Inventory level D2 D1 5…
  30. Question 20 (1 mark, Numerical answer) – The RL of the initial station is 200 m. If 1.54m BS = Δ and 0.45m FS = Δ , then the RL of the last station in m is .
  31. Question 21 (1 mark, Numerical answer) – For the conveyor belt drive shown, the tension on the tight side () 1T is double that of the slack side. The coefficient of friction between belt and…
  32. Question 22 (1 mark, Numerical answer) – In a bord and pillar development district, 6 headings driven along the strike direction are surrounded by panel barriers on the dip and rise sides.…
  33. Question 23 (1 mark, Numerical answer) – A roadway in a mine, a single light source as shown, emits light uniformly in all directions. The floor level illumination at station A is 20 lux. The…
  34. Question 24 (1 mark, Numerical answer) – A system of two identical components connected in series has reliability of 0.25. The reliability of each component is .
  35. Question 25 (1 mark, Numerical answer) – The operational status of an HEMM in a shift is shown in the diagram. The availability of the machine in % is . 1T 2T 400 A B 0 1 8 3 5 6 7.5…
  36. Question 26 (2 marks, Multiple choice) – If c is a constant, the solution of the differential equation 4 9 0 dy y x dx + = is
  37. Question 27 (2 marks, Multiple choice) – Match the following blasting elements with the corresponding initiators. Blasting Elements Initiators P Electric detonator 1 Match stick Q Safety fuse…
  38. Question 28 (2 marks, Multiple choice) – The following plot is developed for a rock type after a series of triaxial tests. The uniaxial compressive strength and tensile strength of the rock…
  39. Question 29 (2 marks, Multiple choice) – Match the following in the context of environmental management. Technique Purpose P Mulching 1 Dust control Q Aeration 2 Noise control R Wet-scrubbing…
  40. Question 30 (2 marks, Multiple choice) – A panel in coal mine produces 400 tonne per day. The number of persons employed in each of the three shifts is 110, 130 and 120. As per CMR, the…
  41. Question 31 (2 marks, Numerical answer) – A right conical iron ore stack on level ground of height 10 m has 60% Fe. The height of the conical stack is extended up to 20 m using iron ore of 50%…
  42. Question 32 (2 marks, Numerical answer) – The feasible region of a linear programming problem is shown in the figure. The maximum value of the objective function 4 3 Z X Y = + is .
  43. Question 33 (2 marks, Numerical answer) – Cash flow of a project of duration 4 years is shown. The uniform income ‘R’, in Rs. crores, at the end of 2nd, 3rd and 4th years for an internal rate…
  44. Question 34 (2 marks, Numerical answer) – The grade values of alumina at three sample locations (A, B and C) in a bauxite deposit are as shown. Using the ‘inverse distance’ method, the…
  45. Question 35 (2 marks, Numerical answer) – Economic feasibility of two methods is examined for meeting a targeted mine production. On a yearly basis, the following cost parameters (Rs in…
  46. Question 36 (2 marks, Numerical answer) – A person standing 50 m away from an HEMM experiences 90 dB sound pressure level. If the person moves to a new location that is 70 m away from the…
  47. Question 37 (2 marks, Numerical answer) – A portion of a ventilation system has two splits as shown. Split ‘A’ has a resistance of 0.2 Ns2/m8 and a regulator of size 2.0 m2. The resistance of…
  48. Question 38 (2 marks, Numerical answer) – Air enters a bord and pillar panel at 10 ppm CO and 20.78% O2. The air at the panel return has 80 ppm CO and 20.52% O2. The ‘Graham’s ratio’ for the…
  49. Question 39 (2 marks, Numerical answer) – In a sublevel stope, 20 m high excavation is made with ring drilling in a 6 m wide orebody. In an effective shift time of 6 hrs, three rings are…
  50. Question 40 (2 marks, Numerical answer) – A coal seam lying at a depth of 200 m is developed by bord and pillar method. Pillars are 30 m centre to centre with a gallery width of 4 m. Unit…
  51. Question 41 (2 marks, Numerical answer) – Following information about a longwall retreating panel is given. Panel length = 1800 m Face length = 150 m Depth of web = 0.6 m Shearer travels at a…
  52. Question 42 (2 marks, Numerical answer) – In a direct rope haulage operating along a 1500 m long incline, 180 tonne of coal is hauled in 7 hours. The average rope speed is 7.5 km/h. The set…
  53. Question 43 (2 marks, Numerical answer) – An SDL of 1.0 tonne capacity operates with a cycle time of 6 minutes. The dimension of the face is 4 m x 3 m. Five blasts are conducted per shift with…
  54. Question 44 (2 marks, Numerical answer) – A force diagram is shown below. Considering clockwise moments to be positive, the resultant moment about A in Nm is . 3 N 7 N 9 N A 120 m 50 m 70 m
  55. Question 45 (2 marks, Numerical answer) – The experiment to determine permeability of a soil sample is illustrated below. The cross- sectional area of the sample is 20.0 cm2. The permeability…
  56. Question 46 (2 marks, Numerical answer) – In underground face blasting, the pull is found to be 10% less than the drillhole length. The headings of 3.6 m width are supported by prop density of…
  57. Question 47 (2 marks, Numerical answer) – The immediate roof of a mine is supported by bolts of length 1.5 m, arranged in 1.2 m x 1.2 m grid pattern. If the unit weight of roof rock is 2.25…
  58. Question 48 (2 marks, Numerical answer) – In a level terrain, a vertical orebody of 20 m uniform width is worked by surface mining method. The density of the ore is 2.5 tonne/m3. The ultimate…
  59. Question 49 (2 marks, Numerical answer) – A 20 m long steel tape used for survey is found to be short by 10 cm. If the area measured with the steel tape is 5000 m2, the actual area in m2 is .…
  60. Question 50 (2 marks, Numerical answer) – The following figure shows the designed blast pattern of a bench. The explosive column is charged at 18 kg/m. If the unit weight of the blasted…
  61. Question 51 (2 marks, Numerical answer) – Two points on the equator have longitudes 55oE and 25oW. Considering radius of earth as 6400 km, the distance between the two points in km is .
  62. Question 52 (2 marks, Numerical answer) – Sum of the series 5, 10, 15, ……….., 500 is .
  63. Question 53 (2 marks, Numerical answer) – The sample standard deviation for the following set of observations is . 40, 45, 50 and 55
  64. Question 54 (2 marks, Numerical answer) – For the given function ( ) ( )( ) , 3 4 f x y x y = + + , the value of f f x y ∂ ∂ + ∂ ∂ at 2 and 1 x y = = is .
  65. Question 55 (2 marks, Numerical answer) – Given 2 6 y x x = + +, the value of ( ) ln d y dx at 2 x = is . END OF THE QUESTION PAPER 4 m 3 m 10 m 3 m 8 m stemming explosive