GATE Machining and Machine Tool Operations: Machining operations, machine tools, cutting tools and tool geometry – Previous Year Questions
14 GATE previous year questions on Machining operations, machine tools, cutting tools and tool geometry (Machining and Machine Tool Operations, Mechanical Engineering) with answers and explanations, from every paper.
14 questions worth 21 marks in all (7 1-mark, 7 2-mark). Asked between 2016 and 2024, so you can see how the topic has been tested over time.
- GATE 2017 ME (ME1) Q65 – Two tools obey Taylor tool-life equations: Tool 1, VT0.1=150; Tool 2, VT0.3=300. V is cutting speed in m/min and T is life in minutes. Find the…
- GATE 2016 ME (ME3) Q33 – Internal gears are manufactured by
- GATE 2016 ME (ME2) Q34 – The following data is applicable for a turning operation. The length of job is 900 mm, diameter of job is 200 mm, feed rate is 0.25 mm/rev and optimum…
- GATE 2017 ME (ME2) Q65 – In orthogonal machining with rake angle 9°, uncut chip thickness is 0.2 mm and chip thickness varies between 0.25 and 0.4 mm. The ratio of maximum to…
- GATE 2018 ME (ME2) Q25 – Feed rate in a slab-milling operation equals .
- GATE 2019 ME (ME2) Q26 – Which cold-forming process presses a hardened tool against a relatively moving workpiece to produce a rough surface with a regular pattern?
- GATE 2019 ME (ME2) Q63 – A 10 mm drill cuts a through-hole in a 15 mm thick aluminium-alloy plate at feed 0.25 mm/rev and 1200 rpm. Specific cutting energy is 0.7 N·m/mm³.…
- GATE 2019 ME (ME1) Q25 – A 400 mm × 40 mm × 20 mm steel sample is reduced uniformly in thickness by 2 mm in one pass using horizontal slab milling. Cutter diameter is 100 mm,…
- GATE 2019 ME (ME1) Q62 – A sharp ASA turning tool has side and end cutting-edge angles 45° and 10°. Feed is 0.1 mm/rev. Find generated surface centre-line average roughness…
- GATE 2020 ME (ME2) Q54 – Two identical shaping machines S₁ and S₂ operate with the same conditions except that S₂ workpiece width is 10% greater and feed 10% smaller. Find…
- GATE 2020 ME (ME1) Q52 – A 25 mm × 25 mm slot is milled in a 300 mm long workpiece using a side-and-face cutter of diameter 100 mm, width 25 mm and 20 teeth. Depth of cut is 5…
- GATE 2021 ME (ME1) Q17 – In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to the plane of the generatrix as shown in…
- GATE 2021 ME (ME1) Q18 – The correct sequence of machining operations to be performed to finish a large diameter through hole is
- GATE 2024 ME Q64 – A flat surface of a C60 steel having dimensions of 100 mm (length) × 200 mm (width) is produced by a HSS slab mill cutter. The 8-toothed cutter has…