GATE Electromagnetics: Transmission Lines – Previous Year Questions
23 GATE previous year questions on Transmission Lines (Electromagnetics, Electronics and Communication Engineering) with answers and explanations, from every paper.
23 questions worth 35 marks in all (11 1-mark, 12 2-mark). Asked between 2014 and 2026, so you can see how the topic has been tested over time.
- GATE 2016 EC (EC2) Q63 – A lossless microstrip has trace width w over a practically infinite ground plane, separated by a slab of thickness t and relative permittivity r>1.…
- GATE 2016 EC (EC2) Q64 – The figure shows lossless lines T 1,T 2 and input reflection magnitude versus frequency. Phase velocity is 2108 m/s in both lines. The length L of T…
- GATE 2017 EC (EC2) Q35 – A two-wire transmission line terminates in a television set. The VSWR measured on the line is 5.8. The percentage of power reflected from the…
- GATE 2014 EC (EC3) Q35 – Transmitter Tx sends a wideband modulated RF signal through the coaxial cable shown to receiver Rx. Transmitter output Z T, cable characteristic Z₀…
- GATE 2014 EC (EC2) Q34 – The shown lossless transmission line is matched to a resistive load by a λ/4 transformer. Find transformer characteristic impedance (Ω).
- GATE 2014 EC (EC2) Q64 – For the transmission line shown, find impedance Zin (Ω) between node A and ground.
- GATE 2014 EC (EC1) Q64 – A parallel-plate transmission line has propagation speed v and characteristic impedance Z. Neglect fringing. Halving plate spacing causes .
- GATE 2014 EC (EC1) Q65 – A lossless line has characteristic impedance 50 Ω. The input impedance of a /8 section is real when terminated by Z L=R+jX Ω. For X = 30 Ω, find R…
- GATE 2017 EC Q34 – The voltage of an electromagnetic wave propagating in a coaxial cable with uniform characteristic impedance is V(l) = e- l + j t Volts, where l is the…
- GATE 2016 EC Q35 – The propagation constant of a lossy transmission line is (2 + j5) m-1 and its characteristic impedance is (50 + j0)\ at = 106 rad s-1. The values of…
- GATE 2018 EC Q20 – The points P, Q, and R shown on the Smith chart (normalized impedance chart) in the following figure represent:
- GATE 2018 EC Q31 – A lossy transmission line has resistance per unit length R=0.05\ /m. The line is distortionless and has characteristic impedance of 50\ . The…
- GATE 2020 EC Q23 – The impedances Z=jX, for all X in the range (-,), map to the Smith chart as
- GATE 2020 EC Q31 – A transmission line of length 3/4 and having a characteristic impedance of 50\ is terminated with a load of 400\ . The impedance (rounded off to two…
- GATE 2021 EC Q45 – The impedance matching network shown in the figure is to match a lossless line having characteristic impedance Z 0=50\ with a load impedance Z L. A…
- GATE 2023 EC Q51 – The S-parameters of a two port network is given as [S]=bmatrixS 11&S 12\ 21&S 22bmatrix with reference to Z 0. Two lossless transmission line sections…
- GATE 2023 EC Q52 – The standing wave ratio on a 50 Ω lossless transmission line terminated in an unknown load impedance is found to be 2.0. The distance between…
- GATE 2023 EC Q54 – The following circuit(s) representing a lumped element equivalent of an infinitesimal section of a transmission line is/are
- GATE 2024 EC Q15 – Consider a lossless transmission line terminated with a short circuit as shown in the figure below. As one moves towards the generator from the load,…
- GATE 2024 EC Q58 – A lossless transmission line with characteristic impedance Z 0=50\ is terminated with an unknown load. The magnitude of the reflection co-efficient is…
- GATE 2025 EC Q64 – A 50 Ω lossless transmission line is terminated with a load Z L of (50-j75) Ω. If the average incident power on the line is 10 mW, then the average…
- GATE 2026 EC Q34 – For a lossless passive two-port network, S 11 and S 21 intersect at –3 dB. For a lossy passive two-port network, S 11 and S 21 intersect at –4 dB. The…
- GATE 2026 EC Q52 – A complex load (in Ω) is represented as L=0.530 on the Smith chart. A co-axial cable with a characteristic impedance of 50 Ω is connected to the load.…